Install The Motherboard - Mercury KN6100M User Manual

Install The Motherboard

Install the motherboard in a system chassis (case). The board is an micro-
ATX size motherboard. You can install this motherboard in an ATX case.
Make sure your case has an I/O cover plate matching the ports on this
motherboard.
Install the motherboard in a case. Follow the case manufacturer's instruc-
tions to use the hardware and internal mounting points on the chassis.
Connect the power connector from the power supply to the PWR1
connector on the motherboard. PWR2 is a +12V connecotr for CPU Vcore
power.
If there is a cooling fan installed in the system chassis, connect the system
cooling fan cable to the SYS_FAN fan power connector on the
motherboard.
Connect the case switches and indicator LEDs to the PANEL1 header.
Pin Signal
1 HD_LED_P(+)
3 HD_LED_N(-)
5 RESET_SW_N(-)
7 RESET_SW_P(+)
9 RSV D_DNU
Chapter 2: Motherboard Installation
Pin Signal
2 FP PWR/SLP(+)
4 FP PWR/SLP(-)
6 POWER_SW_P(+)
8 POWER_SW_N(-)
10 KEY
11