Table of Contents
Advertisement
14
Installing Memory Modules
This motherboard accomodates two 184-pin 2.5V unbuffered Double Data Rate
(DDR)DIMMs. It can support DDR333/266 memory type with 2.5V SSTL-2 DRAM inter-
face. The total memory capacity is 2GB.
DDR SDRAM memory module table
Memory module
Installation Procedure
Refer to the following to install the memory modules.
1
2
3
4
5
6
Memory module
DDR266
DDR333
Do not remove any memory module from its antistatic packaging until
you are ready to install it on the motherboard. Handle the modules only
by their edges. Do not touch the components or metal parts. Always wear
a grounding strap when you handle the modules.
This motherboard supports unbuffered DDR SDRAM only.
Push the latches on each side of the DIMM slot down.
Align the memory module with the slot. The DIMM slots are
keyed with notches and the DIMMs are keyed with cutouts so that they can
only be installed correctly.
Check that the cutouts on the DIMM module edge connector
match the notches in the DIMM slot.
Install the DIMM module into the slot and press it firmly down
until it seats correctly. The slot latches are levered upwards and
latch on to the edges of the DIMM.
Install any remaining DIMM modules.
Installing the Motherboard
Memory Bus
Memory Bus
133MHz
166MHz
Advertisement
Table of Contents
