Honda 2006 Accord Owner's Manual page 490

05/10/03 20:29:33 32SEA630_490
BULB
4. Remove the lens from the bulb
holder by pulling the lens while
squeezing the tabs on both sides
of the holder.
5. Pull the bulb straight out of its
bulb holder. Push the new bulb in
until it bottoms in the bulb holder.
6. Turn on the position lights and
check that the new bulb is
working.
7. Put the lens back on the bulb
holder and push it until it latches.
8. Slide the left side of the light
assembly into the hole. Push on
the right side to latch the
assembly into place.
9. Align and pop the snap fasteners
in place and reinstall the licence
plate garnish.
If you are not sure how to replace
the bulbs, have them replaced by
your dealer.
Lights
487
Maintenance