Honda 2006 Accord Owner's Manual page 483

05/10/03 20:28:39 32SEA630_483
Lights
6. Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
7. Turn on the position lights to
make sure the new bulb works.
8. Put the inner fender cover in place.
Install the holding clips. Lock each
one in place by pushing on the
centre.
480
Maintenance
Replacing Rear Bulbs
(in Fenders)
COVER
1. Open the boot.
Remove the light assembly cover
by pulling its outside edge.
2. Determine which of the two bulbs
is burned out: stop/tail-light or
turn signal light.
BULB
BULB
3. Remove the socket for that bulb
by turning it one-quarter turn
anticlockwise.
4. Pull the bulb straight out of its
socket.
Push the new bulb straight into
the socket until it bottoms.