Video Camera Control Feature - Honeywell LYNX Touch User Manual

The LYNX Touch L7000 supports up to 20 video cameras and provides the capability to view live video from a
maximum of four cameras. The installation of a WiFi Communications module and a WiFi internet connection
are required. Check with your installer to see if this features is available.
Selecting a Camera
Ready To Arm
1 : 2 35
PM
January 12, 2010
Security
Mostly Sunny
68
F
Feels Like 71 F
5-Day Forecast
News
Ready To Arm
Cameras
Name IP
Ready To Arm
Cameras
Name IP
Name 10.10.150.176
Name 10.10.150.159
Name 10.10.150.158
Name 10.10.150.67
Ready To Arm
Cameras
Name IP
Pool 10.10.150.176
Patio 10.10.150.159
Den 10.10.150.158
Living Room 10.10.150.67
Ready To Arm
POOL
DEN
Automation Video
Traffic Notes
5100-100-001-V2
MAC
Back
Scan
5200-100-010-V0
MAC
00:C0:02:7B:67:E4
Back
00:C0:02:8F:60:4E
00:0E:8F:79:C7:EF
00:0E:8F:79:CB:C2
Scan
5200-100-007-V1
MAC
Back
00:C0:02:7B:67:E4
00:C0:02:8F:60:4E
00:0E:8F:79:C7:EF
00:0E:8F:79:CB:C2
Scan
7000-100-019-V1
PATIO
1 2
3 4
LIVING ROOM
7000-100-018-V0

Video Camera Control Feature

1. With the system in the disarmed or armed state, select the
Video icon. The system advances to Cameras screen
2. If no cameras have been discovered or if a list of discovered
cameras is invalid, a Camera scan will start automatically.
Note: The latter can occur if a WiFi connection is lost.
2. A Manual scan can be performed by selecting the "Scan"
button. When the scan is complete the available cameras
will be displayed.
Note: Up to 20 cameras will be viewable during scanning/
enrollment however, only four will appear on each page.
4. Select the desired camera(s) (up to four) from the list by
"tapping" once. If applicable select the " " button to view
additional pages of available cameras. Select the " " button
to return to the previous page of the list.
5. The selected camera(s) are highlighted. To edit the camera
name go to step 6 OR to save the camera go to step 9.
6. To edit the camera name select the highlighted camera again
and then select the edit button.
Note: To de-select a camera "tap" the highlighted camera two
times.
7. Select the "Clear" button on displayed keypad, then enter the
deisred text.
8. Select "Done".
9. Select the "Back" button.
10. The system displays video from the selected camera.
11. To select a different camera, select the camera button then
tap the selected camera two times and repeat steps 4 to 9 as
applicable.
12. Refer to the Video Camera Controls table for information
regarding the Video Function buttons. The available controls
are dependent upon the cameras that have been installed
and selected.
– 57 –
USER FUNCTIONS USER FUNCTIONS
USER FUNCTIONS USER FUNCTIONS