Entry/Exit Delays - Honeywell LYNX Touch User Manual

SECURING THE PREMISES SECURING THE PREMISES
SECURING THE PREMISES SECURING THE PREMISES

Entry/Exit Delays

Entry/Exit Delays Entry/Exit Delays Entry/Exit Delays
Exit Delay
Exit delay begins immediately after arming the system, and gives you time to leave through the designated exit
door without setting off an alarm. The system display will count down the time remaining in the exit delay, if
programmed by your installer. If the system has been Armed Away, a slow beeping will sound throughout the
exit delay period, if programmed by your installer. The exit door must be closed before the end of the exit delay.
During the last 10 seconds of the exit delay fast beeps will sound as a warning that the delay time is nearing its
end. The exit beeps cannot be silenced.
Restarting Exit Delay While System Armed
Ask your installer if this feature is active for your system. If active, you can restart the exit delay one time after
arming in Stay or Away mode during the exit delay by selecting the "Restart" key. This will allowing extra time
for someone to enter or exit or re-enter the property before the system is armed.
Armed Stay - Exit Now
Exit now
28 seconds
Disarm Restart
10:18 AM June 8, 2010
Exit Alarms
To minimize false alarms sent to the alarm monitoring company, your system may have been programmed for
this feature. Ask your installer if Exit Alarm is active for your system.
Whenever you arm the system, the exit delay begins. If an entry/exit door or interior zone is faulted when the
exit delay ends (e.g., exit door left open), the system sounds an alarm and starts the entry delay timer. If you
disarm the system before the entry delay ends, the alarm sound stops and the message "Alarm Cancelled is
displayed, in the system bar. Additionally, Alarm and the faulted zone are displayed with their associated icons
in the system/zone status area. No message is sent to the alarm monitoring company. To clear the exit alarm
condition, the open zone must be secured. To clear the display, select the "Disarm" icon OR depress the "Off"
key and then enter your security code.
If you do not disarm the system before the entry delay ends, and an entry/exit door or interior zone is still open,
the alarm sound continues and an "exit alarm" message is sent to the alarm monitoring company. The message
"Alarm Exit Error" is displayed, in the system bar. Additionally, Alarm and the faulted zone are displayed with
their associated icons in the system/zone status area. The alarm will continue to sound until the system is
disarmed or timeout ocurs. To stop the alarm, the system must be disarmed by selecting the "Disarm"
icon OR depressing the "Off" key and then entering your security code. The message "Alarm Cancelled" is
displayed, in the system bar, indicating that the alarm has been cancelled (if this feature is enabled by the
installer). "Alarm" and the faulted zone continue to be displayed with their associated icons in the system/zone
status area. To clear the display, select the "Disarm" icon OR depress the "Off" key and then enter your security
code a second time. An exit alarm also results if an entry/exit door or interior zone is faulted within two
minutes after the end of the exit delay.
Zones System
Message
More
7000-100-021-V0
– 24 –