Honeywell LYNX Touch User Manual page 27

When an Alarm Occurs
When an alarm has occurred, the touch screen displays the zone number(s) that caused the alarm and the type
of alarm (e.g., "Fire Alarm"). These messages remain displayed until cleared by a user. To clear the display,
note the zone number that is displayed and enter an Off sequence. If the fault cannot be corrected, notify your
alarm company.
Disarming the System and Silencing Alarms
Alarm
Alarm 2 Front
Door
Enter Code:
Cancel
Alarm Cancel
Alarm 2 Front
Door
Disarm
4:43 PM August 11, 2011
1 2 3
4 5 6
7 8 9
Clear 0
5200-100-088-V0
System
Zones
Message
More
7000-100-026-V0
1. Enter a valid Code. The system beeps once and announces
"Disarmed Ready to Arm".
Note: If a valid user code is not entered before the programmed
entry delay occurs, the system remains in alarm mode.
2. "Alarm Cancel" is displayed in a red band along with the zone
that caused the alarm. Select the "Disarm" icon and enter an
second Off sequence to clear the alarm. The system beeps
once, returns to the Security Screen and announces
"Disarmed Ready to Arm".
– 27 –
SECURING THE PREMISES SECURING THE PREMISES
SECURING THE PREMISES SECURING THE PREMISES
Disarming the System