Remote Phone Control Feature - Honeywell LYNX Touch User Manual

The LYNX Touch Series is equipped with a remote interactive phone capability that permits
access to the security system from any off-site touch-tone telephone using all user codes. The
system will provide the appropriate voice messages and any system beeping sounds
indicating the status of the security system over the phone line. (Refer to Summary of
Audible Notification for further information.) The following functions can be performed from
any remote touch-tone telephone:
Disarm the system.
•
Arm the system in STAY or AWAY mode.
•
Bypass zones.
•
Check system status.
•
The remote access session will be aborted if:
A report must be sent.
•
Any local or wireless key entry is made.
•
User Code is not entered within eight (8) seconds of call pickup (during the
•
"system.....system announcement).
No keys are depressed for a period of 15 seconds and while no announcement has been
•
made by the system. Any remote key entry will, however extend this timeout back to 15
seconds.
It will not be possible to begin a remote access session if:
A report must be sent
•
The system is in any Test mode.
•
Panel is in shutdown mode (programmed by your installer).
•
Using Remote Phone Control Feature
Dial the controls's phone number. If no answering machine is present, the control will pick
up between 1 and 14 rings, depending on the number programmed by your installer and will
periodically announce "SYSTEM ENTER CODE". If an answering machine is on the
premises, you need to dial the premises and hang up on the first ring. Wait at least five (5)
seconds (but no more than 22 seconds) and dial the premises phone number again. The
control will pick up and periodically announce "SYSTEM".

Remote Phone Control Feature

– 57 –
USER FUNCTIONS USER FUNCTIONS USER FUNCTIONS USER FUNCTIONS