Arming The System - Honeywell LYNX Touch User Manual

Arming in Stay Mode
Use this mode when you are staying home, but expect someone to use the entrance door later. Close all
protected perimeter windows and doors before arming. The green Ready indicator on the control should be lit if
the system is ready to be armed. When armed in STAY mode, the system will sound an alarm if a protected
door or window is opened, but you may otherwise move freely throughout the premises. Late arrivals can enter
through the designated entrance door without causing an alarm, but they must disarm the system within the
entry delay period or an alarm will occur. If Quick Arm was programmed by the installer, you do not need to
enter the security code to arm the system. The security code must always be used to disarm the system,
however.
If your system's Garage Door Zone has been programmed for burglary protection, the system can be armed
while the Garage Door is opened. A "Fault" will be displayed by the control but will clear once the door has been
closed. The Garage Door zone will be subsequently be monitored by the system.
The Guest Code and Installer Code cannot disarm the system unless it was used to arm the
system. In addition, if the system is armed by pressing via Quick-Arming, neither the Guest Code
nor Installer Code can disarm the system.
Ready To Arm
Arm Away Arm Stay
Delay
10:18 AM June 8, 2010
Ready To Arm
Arm the system in Stay mode
Enter Code:
Cancel Quick Arm
Armed Stay - Exit Now
Exit now
28 seconds
Disarm Restart
10:18 AM June 8, 2010
Zones System
Message
More
7000-100-020-V0
1 2 3
4 5 6
7 8 9
Clear 0
5200-100-015-V0
Zones System
Message
More
7000-100-021-V0
1. Select the Arm Stay icon, the system beeps once and
displays a keypad.
2. Enter a valid User Code.
OR
If Quick Arm has been enabled, select the "Quick Arm" icon.
Note: If a valid user code is not entered or the Confirm icon has
not been selected within 10 seconds, the system returns to
the "home" screen and it will not be armed.
3. The system beeps three times and announces "Armed Stay
Exit Now". The exit delay screen is displayed. If programmed
the display counts down the time remaining in the exit delay.
– 17 –
SECURING THE PREMISES SECURING THE PREMISES
SECURING THE PREMISES SECURING THE PREMISES

Arming the System