Honeywell LYNX Touch User Manual page 34

USER FUNCTIONS USER FUNCTIONS
USER FUNCTIONS USER FUNCTIONS
User Access
Ready To Arm
Master **** Guest ****
Duress ****
Edit Add New
Ready To Arm
Name
User 3
User Code Z-wave Lock Control
Ready To Arm
User3
123!@#
Q W E R T
A S D F G
Z X C V
Clear
abc...
Ready To Arm
Name
Thomas
User Code Z-wave Lock Control
****
Z-wave Unlocking Door
Disarm
Ready To Arm
Master **** Guest ****
Duress ****
Thomas ****
Edit Add New
Delete
5200-100-037-V0
03
No
Save
5200-100-038-V0
Y U I O P
H J K L
B N M
Done
5200-100-039-V0
03
Yes
Save
5200-100-040-V0
Delete
5200-100-041-V0
4. Select the "Add New" key. The system displays the User
screen.
Note: **** Following a User name indicates that a valid 4-digit User
Code has been assigned to the User.
5. Select the "Name" key, the system displays a keyboard.
Note: The Z-wave Lock Control option is only displayed if Z-Wave has
been enabled.
6. If desired you can enter a User Name. Select the "Clear" key
and then enter up to 10 characters of text.
Note: Select the "ABC..." key to switch the keyboard between
upper/lower case or the "123!@#" key to switch to numbers.
7. Once you are finished, select "Done". The system displays
the Keypad screen.
8. Enter the 4-digit code for the new User followed by "Done".
The system returns to the Users Programming screen and
the new User is displayed and along with
9. If a Z-Wave door lock is installed, select the "Z-wave Lock
Control" key to enable the User. The system toggles
between "No" and "Yes". When "Yes" is selected, the User
Code will be synchronized with all enrolled Z-wave door
locks allowing the same User Code to be used at the door
locks.
Note: The number of User Codes supported by each door lock varies
between manufacturers. To ensure compatibility, set the length
of the Master User Code on the door lock to be greater than four
digits.
10. If "Yes" is selected the system displays the "Z-wave
Unlocking Door" key.
11. Select the "Z-wave Unlocking Door" key. The system toggles
between "Disabled" and "Disarm". When "Yes" is selected,
entering a valid User Code with Z-wave Lock Control
enabled at the door lock will disarm the system.
12. Once the User programming is complete select "Save". The
system returns to the Users screen and the new User is
shown.
Note: **** Following a User name indicates that a valid 4-digit User
Code has been assigned to the User.
– 34 –
****.