Access Codes - NEC Electra Elite IPK II Installation And Maintenance Manual

Document Revision 1
___________________________________________________________________________________
For Incoming Calls:
The Dialed Number field is used to match the received called party number. If the
received called party number for an incoming call from another IAD(8)-U( ) ETU does
not match this number, the call is rejected. If the numbers match, the call is presented
on the applicable trunk (port). If the same number is assigned for multiple ports, then
incoming calls will be presented sequentially from lowest port number to highest.
For Outgoing Calls:
This field is used for sending the calling party number in outgoing calls. For the
IAD(8)-U( ) configured for COID/DTI-ANI mode.
S 6 A
ECTION CCESS
This table is used to define access codes that can be dialed from a remote (calling)
system. When the first digit(s) of an incoming call matches any of the entries in this
table, these digits are treated as access codes. Select Add or Delete to insert or
remove an access code.
The contents (entries) in this table must correspond with valid access codes
programmed in Memory Blocks 11-09-xx Trunk Access Code Assignment.. Refer to
the Electra Elite IPK II Programming Manual.
___________________________________________________________________________________
A - 10
C
ODES
Figure A-6 Access Code Parameters
Web-Based Setup and Configuration
H.323 Trunk