Ipk Ii Iad(8)-U( ) Configuration; Configuring Iad(8)-U( ) Etu - NEC Electra Elite IPK II Installation And Maintenance Manual

C h a p t e r 4
___________________________________________________________________________________
S 1 C
ECTION ONFIGURING
When installed for the first time, the IAD(8)-U( ) ETU, comes up with factory set
default parameters as shown in
In this configuration, the ETU cannot run in any randomly given environment, and its
parameters must be redefined before the IAD(8)-U( ) ETU can work in your
environment.
The required parameters can be set by using your web browser and connecting to the
default IP Address (192.168.1.100) in the browser navigation address bar. Refer to
Appendix A Web-Based Setup and Configuration
configuration utility.
S 2 PC P
ECTION
The initial configuration is performed using a PC (or laptop computer) connected to
the IAD(8)-U( ) ETU using a crossover Ethernet cable (one-to-one connection) or
connecting with a hub. Make sure that the PC has the networking parameters set as
shown in
___________________________________________________________________________________
Hardware, Installation and Maintenance Manual

IPK II IAD(8)-U( ) Configuration

IAD(8)-U( ) ETU
Table 4-1 Factory Network Settings
Computer Name
IP Address
Subnet Mask
Default Gateway
ARAMETERS
Table 4-2 Network Settings for the
Table 4-2
IP Address
Subnet Mask
Table 4-1 Factory Network Settings
neciad
192.168.1.100
255.255.255.0
192.168.1.1
for a detailed description of this
PC.
Network Settings for the PC
192.168.1.XXX
255.255.255.0
.
4 - 1