Drain Saddle Installation; Tank Tee Installation - Watts Premier RO-TFM-4SV Installation, Operation And Maintenance Manual

Drain Saddle Installation - Part# 164016
Caution:
If you have a garbage disposal, do not install the drain line near it. Installation of the drain
line must be either above the disposal, or if a second sink drain is available, install it above
the cross bar on the second sink. Installation of the drain line near a garbage disposal
may cause the drain line to plug. If no other installation of drain line is available, Watts
offers drain line installation kits that can be used (part numbers 164014 and 164020) with
garbage disposals.
Step 14 Gather the pieces of the drain saddle
1 Black compression nut
2 Screws
2 Nuts for screws
Step 15 The small square black foam gasket with a circle cut out of the
middle must be applied to the inside of the drain saddle. Remove
sticky tape backing and stick to the drain saddle as shown.
Assemble the drain saddle around the drain pipe at least 1 ½"
Step 16
above the nut of the P-trap to allow for the removal of the P-trap if
necessary. Using a Philips screw driver tighten screws evenly and
securely on both sides of the drain saddle.
Insert a ¼" drill bit into the opening of the drain saddle and drill a
hole in to the drain pipe. NOTE: Take extreme caution to only
drill through one side of the drain pipe and not all the way
through.
Attach black compression nut to the drain saddle, but do not tighten
at this time. The black tubing will be installed later.
Caution: Do not over tighten the screws. It may crack the drain saddle.
Tank Tee Installation - Part# 131023
Step 17 Teflon tape must be applied in a clockwise direction. Wrap (7 to
12 turns) around the male pipe threads (MPT) on the Stainless
Steel fitting on top of the tank.
Step 18 Thread the brass tee (supplied in the parts bag) onto the brass
connection on the top of tank. Tighten using an adjustable wrench.
Caution: Do not Teflon tape the compression fitting threads: If taped, it will leak.
Drain Saddle fits standard 1 ¼" – 1 ½" drain pipes
1 Semicircle bracket with opening
1 Foam washer
1 Semicircle bracket
Page 9