How To Install - Britax Safe-nSound Instructions For Installation And Use Manual

HOW TO INSTALL

INSTALLING INTO VEHICLE (REARWARD FACING)
The restraint is normally packaged in the fully upright forward
facing mode so if you need to use it rearward facing you must
first fully recline the restraint, and then convert the restraint to
rearward facing mode as shown below.
If upper anchorage strap is folded up for storage undo storage
strap then lengthen. Fully press adjuster button (A) while
pulling upper anchorage strap (B) to lengthen.
CONVERT TO REARWARD FACING MODE
A. To fully recline the restraint, move recline foot
by squeezing the foot, squeezing the recline foot
handle while rotating to the rearward facing position
(refer to label on the side of the restraint) until the
handle locks into position. Ensure recline foot locks
into position.
Pull out
16
Fully press Adjuster Button (A)
while pulling Upper Anchorage
Strap (B) to lengthen.
Rotate recline foot
to rearward facing
position
Recline
position
indicator
Rotate
A
Storage
Band
Squeeze Recline Foot
Handle to adjust
B