Britax Safe-nSound Instructions For Installation And Use Manual page 28

HOW TO USE
REMOVING CHILD FROM RESTRAINT
A. Press the upper anchorage strap adjuster button while pulling upper anchorage straps to slacken.
Allow the upper anchorage straps to fall to the sides for easy access into restraint.
B. Lift and hold the harness adjustment lever or push and hold the harness adjustment button
(whichever is fitted) while pulling both shoulder harness straps to slacken harness to the desired
amount.
C. Press the red button on harness buckle. Then both harness tongues will be released. Move each
shoulder strap to child's side into the Harness Tongue Holders then remove the child.
TO REMOVE RESTRAINT FROM VEHICLE
A. Disengage seatbelt tongue from buckle and remove from
the restraint.
B. Fully press the upper anchorage strap adjuster button (1)
while pulling the upper anchorage strap (2) to slacken
as shown right. In some vehicles loosening of the upper
anchorage strap may be difficult. If so, try pushing the
restraint against the vehicle seat back or slightly lifting the
restraint to release the tension.
C. Disengage the attachment clip from the anchor fitting. The
child restraint is now disconnected.
See page 36 for storage of the stabilising bar and the
return to the upright position if required.
28
Fully press Adjuster Button (1)
while pulling Upper Anchorage
Strap (2) to lengthen.
1
Storage
Band
Pull Adjustment
Strap to remove
slack
2