Britax Safe-nSound Instructions For Installation And Use Manual page 38

HOW TO INSTALL
K. Fit the attachment clip on the upper anchorage strap to the
anchor fitting as shown. Make sure to remove as many
twists as possible from the upper anchorage strap.
Always attach the hook and remove slack
L. Tighten the adjustable upper anchorage strap by
pulling the adjustment strap to remove slack as
shown below, but do not over-tighten causing the
restraint base to lift off the vehicle seat.
M. Roll up the excess strap tightly so the webbing is
thick enough to be held in the storage band.
NOTE: Seatbelt extenders should not be used
if the seatbelt is not long enough to secure the
child restraint. If they are used then the buckle
tongue must not enter the seatbelt path.
38
Attachment Clip
Car's Anchor Fitting
Press
Pull Adjustment
Strap to remove
slack
Roll up excess strap
tightly so the webbing is
thick enough to be held
in the storage band.
Storage
Band