Table of Contents
Advertisement
INSTALLING INTO VEHICLE REARWARD FACING
The restraint is normally packaged in the fully upright forward facing mode. If you need to use it rearward
facing you must first fully recline the restraint. Convert the restraint to rearward facing mode by referring to
steps below.
NOTE: Ensure ISOFLEX™ connectors are removed from the storage location before reclining if ISOFIX
low anchorages are to be used.
FULLY RECLINE RESTRAINT:
Place one hand on the front corner of the base while the
other hand lifts the recline latch up to unlock, continue pulling
restraint forward until fully reclined.
The release latch prevents over reclining when installed
forward facing.
CONVERT TO REARWARD FACING
MODE:
Once fully reclined, press the release latch located under
the restraint body while with the other hand lift the recline
latch to unlock, continue pulling the restraint forward until
fully reclined into rearward facing mode.
Locate the stabilising bar under the front flap of the cover.
Lift the flap at the end of the seat to sufficiently access the
stabilising bar. Pull out the stabilising bar fully and then
gently push toward the headrest until you hear a click. The
stabilising bar is now locked in place.
HOW TO INSTALL- PREPARATION
Lift Recline
Latch
Lift Recline Latch
Press Release Latch
Instructions for Installation & Use
31
Advertisement
Table of Contents
