Britax Safe-nSound Instructions For Installation And Use Manual page 37

F. Position the restraint in forward facing
mode and align restraint centrally within the
chosen seating position.
Some vehicle seat fabrics (particularly
velours) may be damaged by a child
restraint used continuously. We recommend
the use of a full Messy Mat™or thick towel
to keep the vehicle seat in good condition.
G. Fully lengthen seatbelt. Insert seatbelt
tongue through the child use seatbelt path
(yellow path), ensuring that the seatbelt is
behind the harness straps and that the lap
part of the seatbelt is below the hooks as
shown.
H. Engage the seatbelt buckle and tongue,
ensure to remove all slack from the lap part
of the seatbelt 1 by pulling sash belt 2.
I. Grasp the sash belt 2 between thumb and
fingers in each hand and allow some slack
in the belt. Now slide the slack belt up into
the lock-off slot, up to the top of the slot.
If the belt is not slack it will not enter the
lock-off slot.
J. Pull the sash belt 2 through the lock-off to
fully tighten the seatbelt. The sash belt 2
must not be tight when feeding it into the
lock-off slot. The child restraint should now
be firmly fitted to the vehicle seat.
Allow the excess sash belt to feed back into
retractor.
HOW TO INSTALL
Slacken the sash
belt and feed into the
lock-off
Ensure lap part of
seatbelt is below
the hooks
J
2
Pull sash
portion of
seatbelt to
remove slack
1
Lap seatbelt
H
I
Pull the sash belt
through the lock-off
to fully tighten the
seatbelt
37