GigE MPTS Address Menu
Use the following procedure to set and view the GigE Multiple Program Transport
Stream (MPTS) address and port of the destination node for the transport stream
output. The GigE MPTS is an address that is represented in the common dotted-
decimal format. Contact the network administrator for details about configuring the
GigE port for operation on your local network.
Press the buttons until the GigE MPTS Address menu appears (shown below).
MPTS Address Field
Press the 4 button until the cursor is at the MPTS Address label, and press the
ENTER button to move into the field. The MPTS Address range is from
000.000.000.000 to 255.255.255.255.
Use the 4 buttons to select the digit to change and then, while the cursor is on
that digit, press the buttons to display the desired value. Repeat this process
for each applicable digit to be changed.
Press the ENTER button to confirm the selection and exit the field.
Port Field
Press the 4 button until the cursor is at the Port label, and press the ENTER button
to move into the field. The Port ID range is from 00000 to 65535.
Use the 4 buttons to select the digit to change and then, while the cursor is on
that digit, press the buttons to display the desired value. Repeat this process
for each applicable digit to be changed.
Press the ENTER button to confirm the selection and exit the field.
DSR-4550
PORT GigE
MPTS Address
E
Port
192.168.000.101
00001
Operating the DSR-4550
49