3
Status4 Menu
Sat Field
Read-only
Freq Field
Read-only
Symb Field
Read-only
Code Field
Read-only
Format Field
Read-only
52
Note: This menu is not displayed when the active signal is received from a source
other than the L-band input connector.
Press the buttons until the Status4 menu appears (shown below). This screen
displays the satellite name and signal tuning characteristics and provides mode-
specific information depending upon the acquisition mode selected (i.e., DCII-
AUTO, DCII-MAN, DVB-MAN, etc.).
STATUS4 Sat Freq
E
This field displays the satellite reference name (two to four alphanumeric
characters) from the downloaded network information. Three dashes (---) are
displayed when no information is available.
This field displays the downlink frequency (range: 950.00 - 2150.00 MHz) of the
L-band signal. This may be different from the frequency that was initially set in the
Manual Tune menu. Three dashes (---) are displayed when no information is
available or that the ASI input is in use.
This field displays the symbol rate (megasymbols per second) of the L-band signal
based on the received signal. Three dashes (---) indicate that no information is
available or when the ASI input is in use.
This field displays the code rate (error control coding for forward error correction)
of the received L-band signal. Three dashes (---) indicate that no information is
available or the ASI input is in use.
Note: This field is excluded from the status display screen when the acquisition
selection mode (see "Modulation Menu" on page 21) is DCII-DVB.
This field displays the format (combined or split) of the L-band signal. Three
dashes (---) are displayed when no information is available or when the ASI input
is in use.
Symb Code Format
---
---
---
---
---