Powering On The Dsr-4550; Chapter 3 Operating The Dsr-4550 - Motorola DSR-4550 Operator's Manual

these internally generated cue tones are used, connect the 600-ohm differential Cue
Tone+ and Cue Tone
The cautions on cable and grounding noted in the audio instructions also apply to cue
tones.
If using ASI output, select the service that is desired on the output. If PID Aliasing is
7.
turned on, the DSR-4550 only outputs the specified service.

Powering On the DSR-4550

To apply power to the DSR-4550, perform the following steps:
Plug the DSR-4550 into a power source and all LEDs on the front panel are illuminated
1.
while the front-panel LCD screen is blank. After approximately 60 seconds, the LEDs
go out and the LCD screen displays a screen similar to the following:
This screen is displayed for only 30 seconds, then the front panel LCD displays the
Main menu.
Proceed with the installation and set up using the front panel menus as described in
2.
"Operating the DSR-4550" on page 11.
DSR-4550
-
terminals on the DSR-4550 to the device receiving the tones.
M O T O R O L A D S R4 5 5 0
V e rs io n x x x x.x x x
Connecting the DSR-4550
9