Set The Control Throws - GREAT PLANES RIFLE1m Instruction Manual

Airplane
Table of Contents

Advertisement

6. Place the Rifl e on the C.G. stand supported by the
dowels on the tape strips on the bottom of the wing. If
necessary, remove the wing to adjust the location of the
battery so the Rifl e balances at the middle marks 1-3/16"
[30mm] from the leading edge of the wing. NOTE: The Rifl e
fl ies well balanced anywhere between the forward and aft
balance marks, but for initial fl ights we advise beginning at
the recommended point.
7. Once you fi nd the location of the battery that allows
the Rifl e to balance, remove the wing and mark the battery
location so it will be repeatable out at the fl ying fi eld.
8. Bevel the front of the included plastic "battery spatula"
and slide it under the battery for easier removal.

Set the Control Throws

1. Remove the propeller and spinner.
2. Connect the battery to the ESC and turn on the
transmitter. If necessary, adjust the sub-trims in your
transmitter so the ailerons and elevator are centered.
3. Measure the throws and use the programming in your
transmitter to make adjustments as necessary. NOTE: The
throws are measured at the widest part of the elevator and
ailerons.
16

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rifle 1m

Table of Contents