LinkPoint 3000/AIO Reference Manual page 11

4. If the PrintPoint 1000, 3000, VeriFone P250, P900, PrintPak 350, Citizen iDP562,
iDP3530 or other compatible printer is used with the LinkPoint 3000 terminal, please
refer to the manual packaged with the printer for installation and operating
instructions.
5. When the terminal is plugged in, it will display the message APP. NOT AVAILABLE
(unless an application is pre-downloaded).
To install the LinkPoint AIO :
1. Find the power input on the back of the AIO terminal near the paper tray (see Figure
7).
3. Connect the male AC adapter plug to the power input at the rear of the terminal (see
Figure 8). The black sleeve that surrounds the plug has a round area that is
unmarked and a flat area that is marked with an arrow. In order to connect the
power adapter, please note that the plug must be turned upside down, so that
the flat area of the sleeve is facing down. The arrow must turned down and
pointing toward the terminal before the cord can be inserted properly. The
sleeve acts as a lock to secure the plug to the terminal. Please note that if the cord
must be disconnected from the terminal, the sleeve must be slid back in order to
disconnect the plug.
4. Plug the adapter into a 120V electrical outlet or into a surge suppressor (see Figure
9).
© 2002 LinkPoint® International, Inc.
GETTING STARTED
Figure 7
Figure 8
5 L3FRR31 Reference Manual