Table of Contents
Advertisement
6.7.
O
P T I C A L
1. With
lens removed from turret, center light image on screen.
FLAT
2. Level console and projector.
3. Install
lens and ensure that corners of screen go dark just as bulb becomes over-
FLAT
focused. If necessary, move projector head using mounting plate adjustments.
4. Run RP-40 loop; adjust so that projected image is level with respect to bottom and side
masking.
5. Rotate lens turret and masking to
6. Run RP-40 loop.
7. Center projected image vertically, using stop adjustment, and laterally, using eccentric
adjustment. Adjust so that projected image is level with respect to bottom and side
masking.
8. With
image vertically centered on screen, rotate lens turret and masking to
SCOPE
9. Center RP-40 image vertically, using stop adjustment, and laterally, using eccentric
adjustment, to match
10. Set focus knobs to the middle of travel range.
11. File aperture plates.
CHRISTIE DIGITAL SYSTEMS CineX35 Projector
May, 2004
6 : C a l i b r a t i o n , A l i g n m e n t , a n d A d j u s t m e n t P r o c e d u r e s
I
A
M A G E
L I G N M E N T A N D
SCOPE
image settings.
SCOPE
A
D J U S T M E N T
.
P
R O C E D U R E S
.
FLAT
6-9
Advertisement
Table of Contents
