Table of Contents
Advertisement
9. Adjust LED power supply output for 4 ±0.5V of video amplitude if necessary.
10. Lock all adjustment screws (items 3, 4, 7, and 9 in Figure 6-2).
6.3.
D
A S H P O T
1. Turn hex-slotted screw counter clockwise at bottom of dashpot assembly until friction of
dashpot is at lowest point.
2. Run wow and flutter test film and increase friction by turning hex slotted screw, at
bottom of dashpot assembly, clockwise until best result is obtained.
6.4.
I
, O
N N E R
NEVER adjust belts with power applied!
WARNING
Belt tension should be kept as loose as possible while remaining tight enough to drive all
mechanisms. To adjust belt tension, follow procedures in Sections 6.4.1 through 6.4.3.
Do not over-tighten belts. If belts are too tight, projector will not
operate properly, and projector parts will wear prematurely.
6 . 4 . 1 .
I
B
N N E R
E L T
Refer to Figure 5-3 on page 5-4.
1. Loosen inner belt tensioner locking screw (item 3 in Figure 5-3).
2. Adjust inner belt tensioner until belt deflection is 0.25 inch (item 1 in Figure 5-3). Belt
should be just tight enough to prevent slapping.
3. Tighten locking screw (item 3 in Figure 5-3).
6 . 4 . 2 .
S
H U T T E R
Refer to Figure 5-4 on page 5-5.
1. Loosen three screws securing adjust plate (item 5 in Figure 5-4).
2. Pull adjust plate (item 5 in Figure 5-4) up until belt deflection is 0.25 inch. It should be
just possible to touch belt together at its midpoint.
3. Tighten screws firmly.
CHRISTIE DIGITAL SYSTEMS CineX35 Projector
May, 2004
6 : C a l i b r a t i o n , A l i g n m e n t , a n d A d j u s t m e n t P r o c e d u r e s
A
D J U S T M E N T
,
S
U T E R
A N D
H U T T E R
T
B
I M I N G
E L T
T
B
A
I M I N G
E L T
D J U S T M E N T
6-5
Advertisement
Table of Contents
