Table of Contents
Advertisement
6 . 2 . 2 .
A
L I G N M E N T
1. Remove analog reader assembly, or rotate assembly downward, for easier access to
Digital Reader Assembly.
2. Set adjustment assembly to center of travel path in both horizontal (item 5 in Figure 6-2)
and vertical (item 8 in Figure 6-2) directions.
3. Run film loop with Dolby Digital track.
4. Adjust vertical positioning by pivoting entire assembly (item 1 in Figure 6-2) and fine
vertical adjustments (item 8 in Figure 6-2) to achieve maximum video signal on
oscilloscope.
5. Adjust with threaded lens holder (item 2 in Figure 6-2) at front of assembly to obtain
highest possible focus reading on DRAS or QC software.
Digital reader has been factory-aligned to meet Dolby specifications.
Field adjustment requires oscilloscope and either DRAS or QC software.
6. Adjust azimuth (item 6 in Figure 6-2) to read zero ±2 mils with DRAS or QC software.
7. Adjust lateral positioning (item 5 in Figure 6-2) to center image on CCD. It should read
zero ±0.5 mils on DRAS or QC software.
8. Magnification should be 100 ±2%; adjust focal distance if necessary.
CHRISTIE DIGITAL SYSTEMS CineX35 Projector
May, 2004
6 : C a l i b r a t i o n , A l i g n m e n t , a n d A d j u s t m e n t P r o c e d u r e s
Figure 6-2: Digital Reader Assembly
P
R O C E D U R E
1: Clamp Mounting
2: Focus Adjustment
3: Vertical Adjustment
Locking Screw
4: Azimuth Adjustment
Locking Screw
5: Horizontal Adjust.
6: Azimuth Adjustment
7: Horizontal Adjust.
Locking Screw
8: Vertical Adjustment
9: Focus Adjustment
Locking Screw
6-4
Advertisement
Table of Contents
