Table Of Contents; Product Specifications - KNOVA KN M-2500W Manuals

TABLE OF CONTENTS

Product specifications ......................................................... 1
Power tool safety ................................................................. 1
Compound Miter Saw Safety ............................................... 2
Electrical requirements and safety ...................................... 3
Accessories and Attachments ............................................. 4
Tools Needed for Assembly
Carton Contents

PRODUCT SPECIFICATIONS

MOTOR
Power Source ...................... 120V AC, 60Hz, 15 Amp
Arbor Shaft Size .................. 5/8 in.
Speed .................................. 4800 RPM (No load)
Brake ................................... Electric
Double Insulated .................. Yes
WARNING
Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains chemicals
(known to the State of California) to cause cancer, birth defects or other reproductive harm. Some examples of these
chemicals are:
• Lead based paints
• Crystalline silica from bricks, cement and other masonry products
• Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to
these chemicals, work in a well-ventilated area and work with approved safety equipment, such as dust masks that
are specially designed to filter out microscopic particles.
WARNING
To avoid electrical hazards, fire hazards or damage to the tool, use proper circuit protection.
This tool is wired at the factory for 110-120 Volt operation. It must be connected to a 110-120 Volt / 15 Ampere time
delay fuse or circuit breaker. To avoid shock or fire, replace power cord immediately if it is worn, cut or damaged in
any way.
Before using your tool, it is critical that you read and understand these safety rules. Failure to follow these rules could
result in serious injury to you or damage to the tool.
POWER TOOL SAFETY:
GENERAL SAFETY INSTRUCTIONS
Safety is a combination of common sense, staying alert and
knowing how to use your power tool.
WARNING
To avoid mistakes that could cause serious injury, do
not plug the tool in until you have read and understood
the following.
1. READ and become familiar with the entire Operator's Man-
ual. LEARN the tool's application, limitations and possible
hazards.
2. KEEP GUARDS IN PLACE and in working order.
Know Your Compound Miter Saw ...................................... 5
Glossary of Terms ............................................................... 6
Assembly and adjustments ................................................ 6
Operation ........................................................................... 10
Maintenance ...................................................................... 13
Troubleshooting guide ....................................................... 14
Parts list ............................................................................. 15
MITER SAW
Cutting Capacity:
Crosscut ............................... 2-5/8 in. x 5-1/2 in.
Miter 45° R & L ..................... 2-5/8 in. x 3-1/2 in.
Bevel 45° L ............................... 1-9/16 in. x 5-1/2 in. L
45° Miter and 45° Bevel ............ 1-9/16 in. x 3-1/2 in.
Rotating Table:
Miter Detent Stops .................... 0°, 15°, 22.5°, 31.6°, 45° R & L
Bevel Positive Stops ................. 0°, 45° L
3. REMOVE ADJUSTING KEYS AND WRENCHES. Form the
habit of checking to see that keys andadjusting wrenches are
removed from the tool before turning ON.
4. KEEP WORK AREA CLEAN. Cluttered areas and benches
invite accidents.
5. DO NOT USE IN DANGEROUS ENVIRONMENTS. Do not
use power tools in damp locations, or expose them to rain or
snow. Keep work area well lit.
6. KEEP CHILDREN AWAY. All visitors and bystanders should
be kept a safe distance from work area.
1