Troubleshooting - Avaya 3920 Installation Manual

4 Installing a Repeater

Troubleshooting

Refer to this section if you encounter problems while using repeaters.
Do not attempt to service this unit yourself. All service must be done by
qualified service personnel.
Condition
There is a lot of
static when calls
hand-off to the
repeater and/or
the LED on the
repeater will not
stop flashing.
You are no
longer able to
connect to the
base.
When you are
on a call, the
handset starts
beeping.
Calls will not
hand-off to the
repeater.
54 Troubleshooting
Suggestion
Move the repeater closer to the base.
Check for interference from electronic
devices.
Make sure the repeater is not too close to
metal objects or thick walls.
Make sure the repeater is powered on.
Reset the repeater and register it to the base
again. See "Registering a Repeater to a
Different Base" on page
Turn off the verification tone. See
the Verification Tone" on page
Make sure the repeater is inside the base's
good signal range.
Make sure there is at least 35 feet between
repeaters.
Reset the repeater and register it to the base
again. See "Registering a Repeater to a
Different Base" on page
Planning and Installation Guide
52.
"Turning on
53.
52.