4 Installing a Repeater
Procedure 1: Install the Repeater Configuration Software
Perform the following steps:
Close all applications on your PC.
1
Insert the repeater configuration software CD into your PC. The installer
2
starts.
Follow the screen prompts, and accept all of the default options.
3
When finished, go to
page
42.
Procedure 2: Register Repeater N to the Base
Before installing a repeater, you need to activate the repeater mode on the base
unit of an Avaya 3920 Wireless Telephone and then register the repeater to the
base unit and any handsets. During automatic registration, the repeater seeks
out the base that is currently in registration mode and registers itself to the base.
Perform the following steps:
1
Set the base of the Avaya 3920 Wireless Telephone into registration mode
by pressing and holding the registration button on the base for 3 seconds.
The indicator on the base flashes.
2
Plug the AC adapter cord into the AC adapter input jack on the repeater.
3
Plug the AC adapter into a standard 120VAC wall outlet near the base unit.
The repeater must be near the base unit. The LED on the repeater flashes
briefly and then remains on. The repeater is now registered to this base and
is ready to use.
Remove the AC adapter from the wall outlet.
4
Unplug the AC adapter cord from the AC adapter input jack on the repeater.
5
The repeater will stay registered to the base.
When finished, go to
42
Installing a Repeater in a Daisy-Chain Configuration
"Procedure 2: Register Repeater N to the Base" on
If the LED continues to flash, try registering the repeater again.
"Procedure 3: Configure Repeater N" on page
Planning and Installation Guide
43.