Procedure 3: Configure Repeater N - Avaya 3920 Installation Manual

Planning and Installation Guide

Procedure 3: Configure Repeater N

In this section, you will connect repeater N to the PC that is running the repeater
configuration software and configure repeater N.
Perform the following steps:
Connect the splitter to the power connector on repeater N. See
1
Plug the AC adapter into a port on the splitter.
2
Plug the customized RJ-11 to serial DB9 PC connection cable into the other
3
port on the splitter.
Plug the AC adapter cord into a standard 120VAC wall outlet.
4
Connect the other end of the customized RJ-11 to serial DB9 PC
5
connection cable to the properly configured COM port on your PC.
Start the repeater configuration software.
6
From the COM port box at the top of the repeater configuration software
7
window, select the COM port to which repeater N is connected.
Click the Load button. The software loads the configuration information
8
from repeater N and displays it in the window.
Record the information displayed in the Repeater RFPI box at the bottom of
9
the window. (You will use this information in the next section.)
If you do not want the handset to beep when it is connected to the repeater,
10
clear the Monitor beep check box, and click the Save button.
Click the Quit button to exit the application.
11
Unplug the AC adapter from the wall outlet.
12
Unplug the splitter from the power connector on repeater N.
13
Unplug the AC adapter from the splitter.
14
When finished, go to "Procedure 4: Configure Repeater N1" on page
Installing a Repeater in a Daisy-Chain Configuration
4 Installing a Repeater
Figure 21.
44.
43