Avaya 3920 Installation Manual page 32

4 Installing a Repeater
Plug the AC adapter into the wall outlet again. The LED on the repeater
3
flashes slowly, indicating that the repeater is in registration mode.
4
Set the base of the Avaya 3920 Wireless Telephone into registration mode
by pressing and holding the registration button on the base for 3 seconds.
The indicator on the base flashes quickly with no interruptions.
5
Using the handset, press the TALK key to go offhook. The LED stops
flashing.
Use the handset's number pad to assign a repeater number. Press a
6
number between 2 and 7. Each repeater number can only be used once
per base. (These numbers are independent of any handset extension
numbers.)
When the repeater has accepted the assignment, the LED flashes a
corresponding number of times.
To confirm the registration, press the STAR key and then the TALK key.
7
The LED goes off for 2 seconds, flashes for a brief moment, and then
remains on and steady.
The repeater is now registered to this base station.
32 Installing a Repeater in a Normal Configuration
The repeater remains in registration mode for a maximum of 5
minutes. If you cannot complete the registration in 5 minutes,
you must repeat this procedure.
If the LED has brief interruptions in the flash, you must reset
your telephone system PIN to 0000 by selecting "CHANGE
PIN" from the registered handset's menu and selecting "0000"
as the PIN.
Planning and Installation Guide