Moving Your Telephone; Swapping Telephones; Cleaning Your Telephone - 3Com 3102 Manual

122 C A: T
HAPTER ELEPHONE
Moving Your
Telephone
Swapping
Telephones
Cleaning Your
Telephone
I M
NSTALLATION AND AINTENANCE
Figure 20 3105 Attendant Console Label Cover Tabs
Each VCX telephones is uniquely identified by an IP address. You can
move your telephone to another location within your calling domain,
connect it to any Ethernet jack on the LAN, and still maintain all of your
personalized features, speed dials, and extension number.
Your administrator assigns a password for your telephone. This password
associates your telephone extension (and mailbox) with your account.
This may allow you to configure another VCX phone in the system to
duplicate your primary phone. This means if you are away from your
primary phone (for example, in a different office), you can program the
local phone to use your extension. Any calls made to your extension will
ring in both locations and you can access your mailbox from either
phone. See the overview section in the chapter that describes your
telephone for more information.
Always unplug your telephone from the power source and from the
network before you clean it. Use a soft cloth dampened with mild
detergent.
After you print the
labels and then cut
them out, remove
the plastic cover
from the Attendant
Console by pulling
up on the two tabs
at the top of the
Attendant Console
until the top of the
cover pops off.