The Usb Device Status Panel; Desk Lights; Dmx Outputs; Linear Time Code (Ltc) Input - High End Systems Hog iPC Handbook

Using Hog® 2PC Software

The USB Device Status Panel

The USB Device Status panel displays the connection status for internal Hog iPC components
as well as external USB devices and adjusts the desk light LED brightness levels.
Note: This panel's default location is slightly to the right of the main
Hog 2PC front panel. This is to allow quick access to the desklight
and LED brightness controls.

Desk Lights

The two mini faders on the right side of the USB Device Status panel are used to control the
desklights and LED brightness. Clicking on the image of the desklight will toggle the
illumination between white and blue.
Note: These setting are remembered by Hog 2PC until changed again.

DMX Outputs

The seven indicators show the state of the seven supported universes of DMX output. Grey
indicates 'not active', green indicates 'operating' and red indicates 'error'. The first four
outputs will always be active on the Hog iPC console and relate to the internal DMX outputs.
The other three become active as USB DMX Widgets or Super Widgets are connected and
configured.

Linear Time Code (LTC) Input

The Hog iPC console contains one internal USB LTC widget and requires no configuration.
The 'Enabled' indicator will turn green when the show currently loaded into Hog 2PC is set to
use timecode input. Please refer to the Wholehog 2 manual for further information on
enabling timecode input.
The 'Receiving' indicator will turn green when valid timecode is detected by the LTC widget.
The value of the incoming timecode will be displayed below this indicator. Note that this
display refers only to the incoming LTC signal, not to any other timecode source (such as MIDI
or simulation).

Expansion Wings

The 'Connected' and 'Receiving' indicator for the first playback wing and the programming
wing will illuminate green to confirm the Hog iPC Frontpanel is connected.
The 'Connected' indicator for the second Playback Wing will turn green when a Playback Wing
is detected. Hog 2PC supports one Playback Wing on the Hog iPC console. The Playback Wing
must be configured through the config dialog before it will operate. The 'Receiving' indicator
will flash green whenever data is received from the Wing.
50 Hog iPC Handbook