Configuring External Usb Dmx Widgets With Hog 2Pc - High End Systems Hog iPC Handbook

Configuring External USB DMX Widgets with Hog 2PC

The Hog iPC console's four internal DMX outputs are pre-configured within Hog 2PC. Each of
the four outputs are mapped to the first four DMX outputs of the Wholehog 2 operating
system. Refer to the Wholehog 2 user manual for details on patching fixtures to these DMX
outputs.
Use the following steps to
install and configure USB
DMX Widgets:
1. Connect the USB DMX
Widget or Super
Widget to a USB port
of the Hog iPC
console. The "Link"
indicator on the
widget should be
illuminated and it will
blink every two
seconds to indicate
that it is functioning
correctly.
2. Right click over the
Frontpanel window
and select the
"Config..." option from
the popup
menu that appears.
The top section of the
Config window is used
to configure USB DMX
widgets to the outputs
of the Hog 2PC application. The Hog 2PC application provides one port for each of the
DMX outputs that a Wholehog 2 console supports when fully 'overdriven'.
The first four ports are already assigned to the internal outputs of the Hog iPC console
and can not be reconfigured. They appear "greyed-out" in the Config window. Widgets
can be configured on Ports 2b, 3b and 4b.
3. Left click on the box associated with the port and select the widget from the list of serial
numbers that appears. A widget may only be connected to only one port at any one time.
If a widget that is already connected to one port is connected to a second port, it will
automatically be disconnected from the first port.
Hog iPC Handbook
Configuring USB Devices
Using Hog® 2PC Software
47