Usb Playback Wings - High End Systems Hog iPC Handbook

4. Click Apply or OK to confirm the selection. The widgets that have been connected should
now have their "Active" "DMX OK" and "TX Mode" indicators illuminated.
5. You can identify which widget is connected to the port by selecting the Beacon button to
the right of the port. The widget connected to that port will flash its indicator lights for a
few seconds.

USB Playback Wings

You can increase the number of physical Masters by adding up to four mini USB Playback
Wings to the console. Configuration is very similar to that of the USB DMX Widgets.
Before you begin configuring connected playback wings, ensure that an USB Playback wing is
connected to an USB port of the console. The "link" indicator on the wing should be illuminated
and it will blink every 2 seconds to indicate that it is functioning correctly.
Use the following steps to configure the wings:
1. Select the Setup key on the Front Panel and then the Control Panel button on the
interface to open the Control Panel.
2. Select the Wings tab. The Hog 3PC application provides one port for each of the possible
playback bars.
3. To configure a wing to a playback bar, click on the box associated with the playback bar
and select the wing from the list of serial numbers that appears. Wholehog 3 Expansion
Wings will appear with their serial number followed by a display number.
Hog iPC Handbook
Using Hog® 3PC Software
39