Configuring Usb Playback Wings With Hog 2Pc - High End Systems Hog iPC Handbook

Using Hog® 2PC Software
Note: A USB DMX SuperWidget will display its serial number followed by
an output number (SN/1, SN/2, SN/3, or SN/4). You can assign any
output of a Super Widget to any available DMX port.
The small button on the right hand side of each port field helps you identify which widget
is connected to it. When you press that button for a port, the connected widget flashes its
indicator LEDs for a few seconds.
4. Click on OK to confirm the selection. The widgets that have been connected should now
have their "Active", "DMX OK", and "TX Mode" indicators illuminated.

Configuring USB Playback Wings with Hog 2PC

The Hog iPC console itself acts as the first Playback Wing that Hog 2PC software controls and
is auto-enabled. It provides 8 playback masters, a grand master, and a manual crossfader. A
second USB Playback Wing can be added to provide an additional 10 playback masters.
You must configure Hog 2PC to use the second Playback Wing by selecting its serial number in
the config dialog, in a similar manner to configuring USB DMX Widgets.
1. After Connecting the Playback Wing to a USB port on the back panel of the Hog iPC
console, right click over the Hog 2PC Frontpanel window and select the "Config..." option
from the popup menu that appears.
The "main" port is already assigned to the Hog iPC console and can not be reconfigured.
The external Playback Wing is configured using the "Rock" port.
2. Left click on the box associated with the Rock port and select the serial number that
appears.
3. Click on OK to confirm the selection.
The controls on the external "Rock" Playback Wing operate in a similar manner to those on the
Hog iPC console except that all ten faders are used as playback masters, giving a total of 18
playback masters.
When using a second Playback Wing as a "Rock" wing, a second playback status bar will be
displayed at the bottom of the third touchscreen window. (To display this window in Hog 2PC,
select Setup → Control Panel and then select a resolution of 640 x 480 for Display 1.)
Clicking on either of the playback bars will 'choose' that master. This is a convenient way of
checking which playback bar references which set of masters.
48 Hog iPC Handbook