Ceramic/Enamel Panels Installation - Valor 739IRN Installation And Owner's Manual

INSTALLATION
The following guidelines apply for all liners.
1. Inside the fi rebox, on the top of each side, release
the screw of the side brick anchors (one per side)
just enough to allow them to rotate.
2. Place the rear panel against the back of the fi rebox,
on the ledge at bottom.
3. Rotate the anchor up and out of the way and slide
the left hand side panel against the fi rebox side.
The panel should be parallel to the edge of the
burner plate. Rotate the anchor back down to hold
the panel.
Rotate anchor up and
insert panel
16

Ceramic/Enamel Panels Installation

Side panels
should be
parallel to
edge of
burner plate
Edge of
burner plate
Position of panel in
relation to burner plate
4. Rotate the anchor up and out of the way and slide
the right hand side panel against the fi rebox side.
The panel should be parallel to the edge of the
burner plate. Rotate the anchor back down to hold
the panel.
5. Tighten the side brick anchors on each side of the
fi rebox.
6. Install the port cover fi xing it using the two screws
already in the fi rebox top.