Window Refi Tting; Wall Switch Kit Installation - Valor 1500IN Installation & Owner's Manual

1. To refi t the window, place it in its bottom railing and
push its top against the fi rebox.
2. While you hold it, pull the side levers back into the
window brackets on each side.
IMPORTANT: To ensure a safe operation,
verify that the levers are hooked properly to the
window tabs; then, pull out the top of the window
and release it to insure the springs return it.
3. Apply light hand pressure against the window frame
sides to bed-in the window seal.
Section Views
CAUTION
DO NOT PUT BATTERIES IN THE REMOTE
CONTROL RECEIVER OR THE BATTERY BOX
until the wires are connected to the burner
control unit as short-circuit could result in the
destruction of the electrical components.
The wall switch kit is connected to the receiver in
the fi replace. The receiver is located on the left side
of the appliance, left of the control valve behind the
appliance's front panel. The battery box is located on
the right hand side of the appliance under the fi rebox.
Window Refi tting
Bottom railing

Wall Switch Kit Installation

Receiver
The receiver and battery box are located inside
the front panel of the appliance.
INSTALLATION
Window frame
Battery box
37