Sony PMW-300K1 Operating Instructions Manual page 60

PICTURE PROFILE SET
Items
Black
Adjusting the black
Black Gamma
Adjusting the black gamma
level
Low Key SAT
Adjusting the low key
saturation
Copy
Copying a picture profile
PP Data
Writing/loading a picture
profile
Reset
Resetting a picture profile
1)
The Area Indication "On"/"Off" setting is common to
all picture profiles PP1 to PP6.
2)
To execute "Color Detection" or "Area Detection"
1.
Select "Color Detection" or "Area
Detection."
A square marker that indicates the detection
area appears in the center of the screen, and
"Execute" and "Cancel" are displayed below.
2.
Select "Execute."
Color-phase detection in the marker area is
performed.
When detection successfully ends, a
completion message is displayed then the
screen is restored.
With Multi Matrix, the target color of multi-
matrix correction is changed to the color
detected by "Color Detection," and the Area
Indication (zebra pattern) appears on the
screen.
With Skin Tone Detail, the target area for the
adjustment is changed to the area centering
around the color detected by "Area
Detection," and the Area Indication (zebra
pattern) appears on the screen.
If detection fails, an error message appears,
then the previous screen is restored.
60 Useful Functions
Subitems and setting values Contents
–99 to +99 (±0)
–99 to +99 (HD: ±0, SD: -16)
–99 to +99 (±0)
Execute / Cancel
Store
Execute / Cancel
Recall
Execute / Cancel
Execute / Cancel
Adjust the master black level.
Adjust the level of black gamma function that
emphasizes only the dark areas of the picture to
clear the tones or on the contrary de-emphasizes it
to reduce noise.
Adjust the level of the low key saturation to
heighten the colors only in the dark areas of the
picture or pale them to reduce noise.
Select "Execute" to copy.
Select "Execute" to store a picture profile on an
SxS memory card.
Select "Execute" to load a picture profile from an
SxS memory card.
Select "Execute" to reset.
3)
Available gamma curves from "Select" in "Gamma"
(STD: Standard gamma, HG: Hyper gamma)
STD1: A gamma table equivalent to an SD camcorder.
STD2: A gamma table with ×4.5 gain.
STD3: A gamma table with ×3.5 gain.
STD4: A gamma table equivalent to the SMPTE-240M
standard.
STD5: A gamma table equivalent to the ITU-R709
standard.
STD6: A gamma table with ×5.0 gain.
HG1: A gamma table for turning 325% D-range input
into 100% output.
HG2: A gamma table for turning 460% D-range input
into 100% output.
HG3: A gamma table for turning 325% D-range input
into 109% output.
HG4: A gamma table for turning 460% D-range input
into 109% output.