Sony PMW-300K1 Operating Instructions Manual page 136

Warning indication
on the viewfinder
1)
HDD A Battery End
Battery Error
Please Change Battery
Backup Battery End
Please Change
Unknown Media(A)
Please Change
Media Error
2)
Media(A) Needs to be
Restored
Media Error
Cannot Record to
2)
Media(A)
Media Error
Cannot Use Media(A)
Will Switch Slots Soon
No Clip
Cannot Use Media(A)
Unsupported File System
Cannot Use Media(A)
In UDF Mode
Same File Already Exists
2)
Change Media(A)
Video Format Mismatch
Copy Protected Input
Cannot Record
Media Error
Playback Halted
2)
Media(A) Error
136 Error/Warning Indications
Buzzer Tally
lamps
Continuous Rapidly
flashing
2)
2)
2)
2)
Cause and measures
The battery of the connected HDD is exhausted. Recording
cannot be performed.
Stop operation to change the battery.
An error was detected with the battery pack.
Replace the battery pack with a normal one.
The remaining power of the backup battery is insufficient.
Replace the battery with a new one.
A partitioned memory card or one that contains recorded clips
exceeding the number permitted with this camcorder is loaded.
This card cannot be used with this camcorder. Remove it and
load a compatible card.
An error occurred with the memory card. The card requires
restoration.
Remove the card, load it again, and restore it.
Recording cannot be done, as the memory card is defective.
As playback may be possible, it is recommended to replace it
with another card after copying the clips, as required.
Neither recording nor playback can be done, as the memory
card is defective.
It cannot be operated with this camcorder. Replace it with
another card.
This is an advanced notice that the camcorder will switch from
the current memory card to the other memory card for
continuous recording.
There are no clips in the memory card.
Check the selected card.
A card of a different file system or an unformatted card was
inserted. It cannot be used with this camcorder.
Replace it with another card or format it with this camcorder.
A memory card incompatible with UDF mode is inserted.
Replace the card from the respective slot, format it with the
camcorder, or switch to UDF FAT mode.
A clip with the same name exists in the memory card to which
you want to copy.
Replace the card from the respective slot with a different card.
The external signal input via the i.LINK connection cannot be
recorded, as the "Format" setting is different from the signal
format of the external input signal.
Change "Format" in "System" in the OTHERS menu to match
it to that of the external signal.
The external signal input via the i.LINK connection cannot be
recorded, as the stream is copy-protected.
Check the input signal.
An error occurred in reading data from the memory card, and
playback cannot be continued.
If this frequently occurs, change the memory card after
copying the clips, as required.
Recording cannot be done, as an error occurred with the
memory card.
If this frequently occurs, change the memory card.