Permanently Setting The Amount Of Water For The Cup Size - Jura IMPRESSA XJ9 Professional Instructions For Use Manual

Permanently setting the
amount of water for the
cup size
E The desired specialty coffee must be prepared within approx-
imately one minute after filling with the ground coffee. Oth-
erwise the IMPRESSA stops the operation and is once more
ready for use.
All specialty coffees with ground coffee are prepared following this
model.
Example: Proceed as follows to prepare one espresso using ground
coffee.
T Place an espresso cup under the coffee spout.
T Open the cover of the filler funnel for ground coffee.
'Please add ground coffee.'
T Place one level measuring spoon of ground coffee into the
filler funnel.
T Close the cover of the filler funnel.
'Please select product:'
T Press the 'Espresso'
Preparation starts. The preset amount of water for espresso
flows into the cup. Preparation stops automatically.
select product:'
It is easy to make permanent settings for the amount of water for all
specialty coffees and hot water according to the cup size. Adjust the
amount once as shown in the following example. Every time you
prepare a drink in the future, this amount of water will be dispensed.
The permanent settings for adapting the amount of water to the cup
size for all specialty coffees and hot water follow this model.
Example: Proceed as follows to permanently set the amount of water
for one coffee.
Precondition: 'Please select product:'
T Place a cup under the coffee spout.
T Press and hold the
'Coffee' and the fill volume are displayed.
T Hold the 'Coffee'
button' appears.
T Release the 'Coffee'
Preparation starts and the coffee flows into the cup.
button.
appears on the display.
is displayed.
'Coffee' button.
button down until
button.
Preparation
'Please
'Enough water? Press