Connecting A Pc For Programming - Notifier NFS-3030/E Installation Manual

Section 3 Installation

3.20 Connecting a PC for Programming

A PC running the VeriFire™ Tools programming utility can upload and download the operating
program of the control panel when attached to J1 Network/Service Connection (NUP) or to the second
Network/Service connection on an attached NCM-W/F. Refer to the VeriFire™ Tools CD for
instructions.
Note: Download operations that change the basic program of the control panel must be performed by
responsible service personnel in attendance at the control panel. After downloading a program, test the
control panel in accordance with NFPA 72-1999.
46
Figure 32 SLC Loop Connections and Wiring
B+ A+ B- A-
SLC Loop Connections
on Loop Control Modules
Channel Channel
B A
B+ A+ B- A-
the same for Loop
Style 4 SLC Loops
Control Modules
B+ A+ B- A-
TB1
SLC Loop #2 Connections
on Loop Expander Module
Channel B (output loop)
SLC loop
connections are
B+ A+ B- A-
Expander and
NFS-3030 Installation PN 51330:C 10/28/2003
Connecting a PC for Programming
TB1
Channel A (loop return)
T-Tapping is not allowed
on a four-wire SLC.
Style 6 SLC Loops