Remote Control - Kelvinator KSV26CRE User Manual

Remote control

2
1
4
5
7
8
9
10
1 On/OFF Button
Push this button to start or stop operation.
Mode
2 MODE Select Button
Each time you push the button, a mode is selected in
a sequence that goes from AUTO, DEHUMIDIfY, fAN,
COOL and HEAT, as the following figure indicates:
AUTO DEHUMIDIFY
NOTE: Cooling Only models have no HEAT mode.
3 lIGHT Button
Light
Press this button to switch the indicating lights of the
indoor unit ON or OFF. The normal condition at start up
is ON.
4 FAn Button
By pressing this button, Auto, Low, Medium and High
speed can be progressively selected. When the unit is
turned on, Auto fan speed is the default.
In DEHUMIDIfY mode, the fan speed is fixed at
low speed.
5 TURBO Button
Press this button in COOl or HEAT mode to put the fan
into the high speed Turbo mode and the air conditioner
will work at maximum power.
Press again to cancel this function.
3
6
13
11
12
14
FAN COOL HEAT
6 X-FAn Function
Press the X-FAn button to activate the X-FAN
function.
After the unit is turned off, the indoor fan will continue
to operate for 10 minutes to remove all moisture from
the indoor unit and prevent bacteria and mildew from
growing.
7 TIMER On Button
Press this button to set the start time.
8 TIMER OFF Button
Press this button to set the start time.
9 SWInG Button
Press this button to change the swing angle of the
louvre. The angle of the horizontal louvre will adjust by
6 degrees with each press of the button. If you keep
pressing the button for 2 or more seconds, the louvre
will swing up and down automatically.
10 I FEEl Button
Push this button to initiate the I FEEl feature,
the remote displays the temperature at its location.
The remote control will send this signal to the air
conditioner in 3 minute intervals until you press the I
FEEl button again. The air conditioner will automatically
cancel the I FEEl feature if it does not receive the signal
during any 7 minute interval.
NOTE: The I fEEl feature is not available under
DRY and fAN mode. Shifting the operating mode
or turning off the unit will cancel the I fEEl feature
automatically. The remote control needs to be
within 8m reach of the indoor unit for the I fEEl
mode to work appropriately.
11 COnTROl Buttons
Press the button to increase the temperature setting.
Press the button to decrease the temperature setting.
In TIMER ON/Off or ClOCK functions, use these
buttons to adjust the timer or set the clock.
12 ClOCK Button
Press this button and the Clock symbol
You can press Control buttons
you want.
13 TEMP (Temperature) Button
Press this button to change the remote control display of
the set temperature to the room temperature.
14 ECO (Economy) Button
Press this button to go into the Energy-Saving operating
mode. Press it again to cancel. This function is ideal for
maintaining a comfortable sleeping temperature.
Kelvinator Air Conditioning Using the remote control 7
will blink.
and to set the time