Ganz ZC-PT Series User Manual page 41

HOME SETTING
HOME FUNCTION
SELECT MODE
PRESET POINT
RETURN TIME
GO
EXIT
•
HOME FUNCTION
The item is used to enable or disable the HOME function. Use the left/right
direction keys of the control keyboard to change the setting.
•
SELECT MODE
Select one of the modes that the PTZ Camera should execute when the
HOME function is enabled and the RETURN TIME expires. The options
include <AUTOPAN>, <SEQUENCE>, <CRUISE> and <PRESET>. Use the
left/right direction keys of the control keyboard to change the setting, and the
items below will change in cooperating with your selection.
•
PRESET POINT
Select a preset point where the PTZ Camera should go after the Return Time
function, which will be mentioned later, is activated. The preset point(s)
should be set prior either in the PRESET setup menu or through the
keyboard.
SEQUENCE LINE
Select a sequence line that the PTZ Camera should execute after the
Return Time function is activated. The sequence line(s) should be
defined prior either in the SEQUENCE setup menu or through the
keyboard.
AUTOPAN LINE
Select an auto-pan line that the PTZ Camera should execute after the Return
Time function is activated. The auto-pan line(s) should be defined prior either
in the AUTOPAN setup menu or through the keyboard
CRUISE LINE
Select a cruise line that the dome camera should execute after the Return
Time function is activated. The cruise line should be defined prior either in the
CRUISE setup menu or through the keyboard.
•
RETURN TIME
The camera starts to count down RETURN TIME when the dome idles, and
then execute the SELECT MODE function when the return time
RETURN TIME ranges from 1 to 128 minutes.
OFF
PRESET
001
001 MIN.
ENTER
YES
User's Manual
is up
. The
40