Download  Print this page

Aligning The Wall Plate - Frigidaire MWV150KB Installation Instructions Manual

Over the range microwave oven
Hide thumbs

Advertisement

Table of Contents

ALIGNING THE WALL PLATE

D.
CAUTION: Wear gloves
to avoid cutting fingers on
sharp edges.
1
Draw a vertical line on the wall at the center of the
30" wide space.
2 Draw a horizontal line on the wall at the bottom of
"Rear Wall Template".
3 Find a wall stud in area "E" of mounting plate
Refer to section 1B. Finding the wall studs.
4
For attaching the mounting plate into stud drill
a 3/16" hole into wood stud. Drill a 5/8" hole for
toggle bolt in 1 other location (Hole A or Hole B)
NOTE: DO NOT MOUNT THE PLATE AT THIS
TIME.
Installation Instructions
NOTE: IT IS VERY IMPORTANT TO
READ AND FOLLOW THE DIRECTIONS
IN THE INSTALLATION INSTRUCTIONS
BEFORE PROCEEDING WITH THIS
REAR WALL TEMPLATE.
This Rear Wall Template serves to position the bottom
mounting plate and to locate the horizontal exhaust
outlet.
1. Use a level to check that the template is positioned
accurately.
2. Locate and mark at least one stud on the left or
right side of the centerline.
It is important to use at least one wood
screw mounted firmly in a stud to support the weight
of the microwave. Mark two additional, evenly spaced
locations for the supplied toggle bolts.
3. Drill holes in the marked locations. Where there is
a stud, drill a 3/16" hole for wood screws. For holes
that do not line up with a stud, drill 5/8" holes for
toggle bolts.
DO NOT INSTALL THE MOUNTING PLATE
AT THIS TIME.
4. Remove the template from the rear wall.
5. Review the Installation Instruction book for your
installation situation.
Darle vuelta a la hoja para consultar la
versión en Español.
Locate and mark holes to align with holes in the
mounting plate.
IMPORTANT:
LOCATE AT LEAST ONE STUD ON EITHER SIDE OF
THE CENTERLINE.
MARK THE LOCATION FOR 2 ADDITIONAL, EVENLY
SPACED TOGGLE BOLTS IN THE MOUNTING PLATE
AREA.
Hole B
Horizontal Line
Area E
3/8" TO EDGE
12"
Trim the rear wall template along the dotted line.
4"
Locate and mark holes to align with holes in the
mounting plate.
IMPORTANT:
LOCATE AT LEAST ONE STUD ON EITHER SIDE OF
THE CENTERLINE.
MARK THE LOCATION FOR 2 ADDITIONAL, EVENLY
SPACED TOGGLE BOLTS IN THE MOUNTING PLATE
Centerline
AREA.
Draw a Vertical Line
notches
on Wall from Center
of Top Cabinet
Hole A
C L
Draw a horizontal line on wall at the
bottom of "Rear Wall Template".
NOTE: Holes A and B are inside area E. If neither of
Holes A and B are not in a stud, find a stud somewhere
in area E and draw a circle to line up with the stud. It is
important to have at least one wood screw mounted
firmly in a stud to support the weight of the
microwave. Set the mounting plate aside.
EN-8
Horizontal Line

Advertisement

Chapters

Table of Contents
loading

  Related Manuals for Frigidaire MWV150KB