Fiber Optic Ethernet Ports; Sfp Optic Ethernet Ports - Siemens RUGGEDCOM RSG2200 Installation Manual

RUGGEDCOM RSG2200
Installation Guide
For specifications on the available copper Ethernet ports, refer to
Specifications".
Section 3.2

Fiber Optic Ethernet Ports

Fiber optic Ethernet ports are available with either MTRJ (Mechanical Transfer Registered Jack), LC (Lucent
Connector), SC (Standard or Subscriber Connector) or ST (Straight Tip) connectors. Make sure the Transmit (Tx)
and Receive (Rx) connections of each port are properly connected and matched to establish a proper link.
1
Figure 21: MTRJ Port
1. Tx Connector 2. Rx Connector
1
Figure 23: SC Port
1. Tx Connector 2. Rx Connector
For specifications on the available fiber optic Ethernet ports, refer to
Specifications".
Section 3.3

SFP Optic Ethernet Ports

SFP (Small Form-Factor Pluggable) optic Ethernet ports are available with LC (Lucent Connector) connectors.
Make sure the Transmit (Tx) and Receive (Rx) connections of each port are properly connected and matched to
establish a proper link.
Fiber Optic Ethernet Ports
Pin
6
7
8
2
Figure 22: LC Port
1. Tx Connector
2
Figure 24: ST Port
1. Tx Connector
Name
10/100Base-TX 1000Base-TX
TX- BI_DA-
Reserved (Do Not Connect)
Reserved (Do Not Connect)
Section 4.4, "Copper Ethernet Port
1
2. Rx Connector
1
2. Rx Connector
Section 4.5, "Fiber Optic Ethernet Port
Chapter 3
Communication Ports
Description
Transmit Data-
or Bi-Directional
2
2
21