Fiber Optic Ethernet Ports - Siemens RUGGEDCOM RS416 Installation Manual

Chapter 3
Communication Ports
RJ45 receptacles at either end. Ground loops can cause excessive noise and interference, but more
importantly, create a potential shock hazard that can result in serious injury.
LEDs
Each port features LEDs that indicate the state of the port.
1
Figure 18: RJ45 Port LEDs
1. Speed LED 2. Link/Activity LED
Pin-Out
The following is the pin-out for the RJ45 male connectors:
8
Figure 19: RJ45 Ethernet Port Pin Configuration
Specifications
For specifications on the available copper Ethernet ports, refer to
Specifications".
Section 3.2

Fiber Optic Ethernet Ports

Fiber optic Ethernet ports are available with either MTRJ (Mechanical Transfer Registered Jack), LC (Lucent
Connector), SC (Standard or Subscriber Connector) or ST (Straight Tip) connectors. Make sure the Transmit (Tx)
and Receive (Rx) connections of each port are properly connected and matched to establish a proper link.
20
LED
2
Speed
Link/Activity
1
State
Yellow
Off
Yellow (Solid)
Yellow (Blinking)
Off
Pin Name
1 RX+
2 RX-
3 TX+
4 Reserved (Do Not Connect)
5 Reserved (Do Not Connect)
6 TX-
7 Reserved (Do Not Connect)
8 Reserved (Do Not Connect)
Section 4.3, "Copper Ethernet Port
RUGGEDCOM RS416
Installation Guide
Description
The port is operating
at 1000 Mbps
The port is operating
at 10 or 100 Mbps
Link established
Link activity
No link detected
Description
Receive Data+
Receive Data-
Transmit Data+
Transmit Data-
Fiber Optic Ethernet Ports