Siemens RUGGEDCOM RSG2200 Installation Manual page 9

RUGGEDCOM RSG2200
Installation Guide
Display Mode Indicator LEDs
Mode button
Alarm Indicator LED
Power Module Indicator LEDs
RS232 Serial Console Port
Ports, Controls and Indicator LEDs
• Orange (Solid) = Half duplex mode
• Off = No link detected
When Speed mode is selected, these LEDs indicate the port speed.
• Green (Solid) = 1000 Mb/s
• Green (Blinking) = 100 Mb/s
• Orange (Solid) = 10 Mb/s
• Off = No link detected
These LEDs indicate the current display mode for the port status indicator LEDs (i.e. Status,
Duplex or Speed).
The Mode button sets the display mode for the port status indicator LEDs (i.e. Status,
Duplex or Speed). It can also be used to reset the device if held for 5 seconds.
The alarm indicator LED illuminates when an alarm condition exists.
These LEDs indicate the status of the power modules.
• Green = The power supply is supplying power
• Red = Power supply failure
• Off = No power supply is installed
This port is for interfacing directly with the device and accessing initial management
functions.
Chapter 1
Introduction
3