Gbic Optic Ethernet Ports; Installing A Gbic Optical Port - Siemens RUGGEDCOM RSG2200 Installation Manual

Chapter 3
Communication Ports
Section 3.4

GBIC Optic Ethernet Ports

GBIC (Gigabit Interface Converter) optic Ethernet ports are available with SC (Standard or Subscriber Connector)
connectors.
Figure 28: SC Port
1. Tx Connector 2. Rx Connector
The following sections describe how to install and remove GBIC optical ports:
• Section 3.4.1, "Installing a GBIC Optical Port"
• Section 3.4.2, "Removing a GBIC Optical Port"
Section 3.4.1

Installing a GBIC Optical Port

To install a GBIC optical port, do the following:
CAUTION!
Electrical hazard – risk of damage to equipment. Use only components certified by Siemens with
RUGGEDCOM products. Damage to the module and device may occur if compatibility and reliability
have not been properly assessed.
CAUTION!
Electrical hazard – risk of damage to equipment. Make sure all electrostatic energy is dissipated
before installing or removing components from the device. An electrostatic discharge (ESD) can cause
serious damage to the component once it is outside the chassis.
1. Make sure all potential electrostatic build-up has been properly discharged to prevent electrostatic
discharges (ESD). This can be accomplished by wearing an ESD wrist strap or by touching Earth or the
chassis ground.
2. Remove the dust cover from the port opening in the module.
CAUTION!
Mechanical hazard – risk of component damage. GBIC optical ports are designed to insert in only
one orientation. Do not force the port into the module.
3. Remove the port from its packaging.
4. Squeeze the latches on either side of the port and insert the port into the module.
24
1
RUGGEDCOM RSG2200
Installation Guide
2
GBIC Optic Ethernet Ports