Fiber Optic Ethernet Ports - Siemens RUGGEDCOM RS910L Installation Manual

RUGGEDCOM RS910L
Installation Guide
Section 3.2

Fiber Optic Ethernet Ports

Fiber optic Ethernet ports are available with either MTRJ (Mechanical Transfer Registered Jack), LC (Lucent
Connector), SC (Standard or Subscriber Connector) or ST (Straight Tip) connectors. Make sure the Transmit (Tx)
and Receive (Rx) connections of each port are properly connected and matched to establish a proper link.
Port Types
1
Figure 12: MTRJ Port
1. Tx Connector 2. Rx Connector
1
Figure 14: SC Port
1. Tx Connector 2. Rx Connector
LEDs
Each port features an LED that indicates the link/activity state of the port.
State
Yellow (Solid)
Yellow (Blinking)
Off
Specifications
For specifications on the available fiber optic Ethernet ports, refer to
Specifications".
Section 3.3
EoVDSL Ports
Ethernet over VDSL (EoVDSL) connections operate in pairs with one device configured as the Master and the other
as the Slave. In VDSL (Very-high-bit-rate Digital Subscriber Line), the terms Central Office (CO) or Line Termination
Fiber Optic Ethernet Ports
2
Figure 13: LC Port
1. Tx Connector 2. Rx Connector
2
Figure 15: ST Port
1. Tx Connector 2. Rx Connector
Description
Link established
Link activity
No link detected
1
1
Section 4.4, "Fiber Optic Ethernet Port
Chapter 3
Communication Ports
2
2
19